Hotkey Settingĭefault hot-key is the right Ctrl (the Ctrl key on right side of keyboard). Keyboard Hot-key Switch : Double click the rightCtrl + Port Number +Enter VIII. Double click the middle roller of mouse, then press the left mouse button to switch to the previous port. Double click the middle roller of mouse, and then press the right mouse button to switchī. Switch Modesīutton Switch: Switch to any port by buttons on front panel.Ģ port dual KVM switch: Double click the mouse middle roller for circular switching (within 1 second)Ī. Select Duplicate or Extend, then the two monitors can be displayed at the same time per selected display mode. Take win7 as an example: hold down the keyboard windows + P, as shown in the figure, a dialog will pop up as below. Note: The monitors take around 20 seconds to display at first set-up, later on it only takes around 2-3 seconds to display upon switching. Set computer display modes to extended display / duplicated display as needed.Power on the switch and boot all devices.Plug in your speaker or microphone if needed.Connect your Monitors to HDMI OUT 1 & 2 if your monitor has both HDMI2.0 input and HDMI1.4 Input (1080P/ ), please plug in the HDMI1.4 Input.Plug your mouse and keyboard to correspondent USB mouse and keyboard port on back panel for gaming or mechanical keyboard, please plug them into the USB 2.0 HUB on front panel if they did not work well on USB keyboard port.Repeat step 2 & 3 to connect other input devices to correspondent KVM ports.Connect Cable B from your computer to IN 1 B of the Switch (If an adapter is needed, please connect your adapter with Cable B.Connect Cable A from your computer to IN 1 A of the Switch.Outsourced adapters or docks are beyond our control, make sure you get those.If a USB C Dock has dual video outputs, make sure it supports extended display (some only supports duplicated display). If VGA to HDMI adapter needed, make sure it has built-in chips and separate power supply.Most computers and laptops only have one HDMI output + VGA/DVI/DP output or USB C output, make sure you have VGA/DVI/DP to HDMI adapter or USB C Dock ready before setup, you may need multiple adapters for multiple computer connection. Important Reminder before Set-up:ĭual monitor display requires dual video inputs. Auto Scan Mode for monitoring all computers /DVR/NVR With USB2.0 Hub and separate audio & microphone output III. With memory function in case of power-down Support independent mouse keyboard switch, even without USB signal input, you can switch the input device easily by keyboard or mouse. ![]() ![]() Please read the below setting operation instructions ). Multiplatform support: Windows /XP/VistaLinux and Mac Support hot plug & play Support HDCP and auto EDID for Dual HDMI KVM Switch Support DDC2 for Dual VGA KVM Switch Support auto detection if one computer is powered off, the switch will automatically switch to the next powered-on computer (The default is in closed state,if you want to open it. Support extended or duplicated display depending on computer setting. One USB console controls 2/4 multi-graphics card dual-output computer and other devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |